Last reviewed November 12, 2026 by Vancouver Picks Editorial Team

Why breakers trip
A breaker is a safety switch. It cuts power when a circuit draws more current than it's rated for or when it detects a fault. The usual causes:
- Overload: too many devices on one circuit (space heater + kettle + microwave is a classic).
- Short circuit: a hot wire touching neutral or ground, often from damaged cords or devices.
- Ground fault: current leaking to ground, common in kitchens, bathrooms and outdoors.
Before you touch the panel
- Make sure your hands and the floor are dry.
- Use a flashlight if the area is dark.
- Don't remove the panel cover. Resetting only involves the switches on the front.
- If you see scorch marks, smell burning, hear buzzing, or the panel is hot, stop. Call an electrician.
How to reset a tripped breaker
- Unplug or switch off devices on the affected circuit to remove the load.
- Open the panel door and look for a switch that sits in the middle position or is out of line with the others. Some breakers show a red or orange flag when tripped.
- Push the switch firmly to OFF first. Most breakers won't reset unless you go fully off.
- Then push it to ON.
- Plug devices back in one at a time. If the breaker trips again right away when a specific device goes on, that device may be the problem.
Don't forget GFCI outlets
If a bathroom, kitchen, garage or outdoor outlet is dead but no breaker has tripped, look for a GFCI outlet (the one with TEST and RESET buttons). One GFCI can protect several outlets downstream. Press RESET firmly. Test GFCIs monthly with the TEST button.
Label your panel
While you're there, check that every breaker is labelled clearly. It saves time in an emergency and helps any electrician who works on your home later.
When a breaker keeps tripping
Repeated trips are a warning, not an inconvenience. Call a licensed electrician if:
- The breaker trips again immediately with nothing plugged in
- It won't stay in the ON position
- Lights flicker or dim regularly
- Outlets or switch plates feel warm
- Your home has an older panel or you're adding big loads like an EV charger or heat pump
In BC, most electrical work beyond simple resets requires a licensed electrical contractor or a permit through Technical Safety BC. Request quotes from local electricians using the form on this page.
Frequently asked questions
Is it safe to reset a breaker myself?
Yes, flipping the switch off then on is safe if the panel shows no burning, heat, buzzing or damage and your hands are dry. Never remove the panel cover.
Why does my breaker trip when I use a space heater?
Space heaters draw a lot of current. Combined with other devices on the same circuit, they often overload it. Move the heater to another circuit.
How many times can I reset a breaker?
If it trips more than once with normal use, stop resetting and have an electrician investigate.
Looking for electricians?
See electricians across Metro Vancouver →